Page 9 of 13
Operating LED Work Light
1. Press the Light button to turn on the LED light
2. The LED light has multiple functions, (ON-SOS-Flash-OFF) , press light button to select the
desired function. And turn off the LED light after use. Failure to do so may discharge the internal
battery to dead.
3. Recharge the power pack immediately after use. Refer to Recharging the Power Pack with AC
Charger
Jumpstarting an Engine
1. Make sure your vehicle is a negative ground system. If it is a positive ground system vehicle or
you are unsure, please consult the vehicle’s owner’s manual.
2. Check the battery status before boosting engine by pressing any button on right of the LCD.
3. Turn off all accessories in vehicle.
4. Engage the park/emergency brake of the vehicle.
5. Engage the transmission in park mode for an automatic transmission vehicle or engage the
transmission in neutral for a manual transmission vehicle.
6. Place the booster pack on a flat, stable surface close to the battery of the vehicle.
7. Connect the negative (black) clamp from the power pack to the chassis of the vehicle.
8. Connect the positive (red) clamp from the power pack to the positive (+) terminal of the battery in
the vehicle.
9. If the connection is correct, the green indicator on positive side panel is on, the move to step 11.
10. Disconnect the clamps from the battery of the vehicle if the connections are reversed ( RED
reverse polarity indicator is ON and alarm is sounding), and repeat the steps 7 , 8 and 9, then
proceed to step 11.
11. Turn ON the boosting power switch of the power pack when the correct connection indicator is on .
12. Crank the engine for 1
–3 seconds or until it starts, whichever is first.
13. Turn OFF the ON/OFF switch after using the booster pack.
