9
Mounting the Wireless Transmitter for console control operation
1.
Remove the wireless transmitter from the plastic console-mounting bracket by
slightly bending the tab back to release the wireless transmitter from bracket.
2.
Place the wireless transmitter in the desired location and orientation. Test
systems by operating the spotlight in all directions to verify you do not have
interference between the locations.
3.
The location for mounting the bracket should be a smooth, flat surface. Be sure
you will have access to the underside of the chosen location, and that you will be
able to drill holes there without damaging existing wiring or structures.
4.
Use the bracket as a template to mark mounting holes on a flat surface that is
convenient for operation of the light.
5.
It is recommended to use marine grade plywood as a back plate to strengthen the
installation.
6.
Drill the two 3/16 (4.5 mm) holes through the mounting surface at the marked
points.
7.
Apply a small amount of non-silicone sealant (such as StarBrite
Boat Caulk
#83801) where the screws penetrate the mounting surface.
8.
Fasten the bracket securely to the mounting surface using the two 6-32 x2”
(3.5mm x 50mm) flat head stainless steel screws, flat washers, and locknuts
provided with the light. Do not over tighten.
Battery Replacement
Only the wireless transmitter requires a battery. Replace only with a 12 Volt Alkaline
A23 battery. See section on page 3 titled
Installing Transmitter Battery
.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
