7
7. Record setting for any additional wireless transmitters.
8. Make sure membrane and top cover is re- assembled correctly with buttons
protruding fully.
9.
Carefully snap top cover / membrane on to lower assembly. It should only take
light pressure to snap in place.
10.
Test battery connection by pressing any of the buttons. When doing so, the red
LED indicator should turn on in the upper left hand corner. If the LED does not
illuminate, separate the covers and check the battery polarity. If the battery
polarity is correct, replace the battery. See Figure 1, page 3, in section titled
Installing Transmitter Battery.
11.
Re-install the 2 screws on the back cover and tighten them.
Initializing the System
1.
Connect the red wire from the light to 12V DC power (+) and the black wire to
ground (-). (Connections-minimum 14 gauge wire). The power must be fused for
10 Amps.
2.
Within 5 seconds of applying power to the light you must activate the unit with
your wireless transmitter by pressing the green On/Off button 2-3 times.
3.
If pressing the green On/Off button does not turn the light on and off, try pressing
the directional control buttons to see if the light moves in the direction indicated. If
there is no movement check to make sure the wiring to the spotlight is correct and
measures approximately 12 volts DC. Disconnect power to the spotlight for 5
seconds then reconnect power and press the green On/Off button to register the
transmitter frequency. If you still have a problem, call the Guest Company Service
Department. See page 10 for contact information.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
