730385.doc
8
Base mounting gasket For Spotlight
728372
Safety glass lens
B-23186
Relay PC Board 500A
730511
Spotlight Reflector
D-23127
Gasket For Control Panel
729962
NOTE:
THE CONTROL PANELS USED WITH GUEST MODELS 501A, 502A, OR 503A WILL
NOT
OPERATE THE MODEL 500A SPOTLIGHT.
Troubleshooting
Under normal use, your Guest Beamer spotlight will provide you with many
years of reliable service.
If an operational problem occurs:
Confirm that all fuses are intact.
If a fuse
has
blown, do not replace the
fuse until the cause of the problem has been located and corrected. NEVER replace a
blown fuse with a higher value fuse.
Most problems are caused by poor wiring connections.
Confirm
that all wiring connections are accurate
and well made. Be sure that the spotlight and
control are connected to a 12 volt DC power source capable of supplying 10 amps
even while other equipment is operating. (See diagram on page 5.)
If the spotlight does not move or light
, remove the 4 bolts that fasten
the spotlight onto the mounting surface and gently lift the light until you can see
inside
its base . Avoid cutting any wires. Gently inspect the base for broken
connections. Examine the circuit board for loose plug connectors, blackened
components or corrosion. Replace the circuit board if it appears damaged. If there are
no loose wires or signs of water penetration, re-install the spotlight and then replace
the control pad.
