730385.doc
6
results use waterproof telephone splices or solder the wire connections,
and then cover
them with heat-shrink tubing.
This spot/flood light requires a source of 12 volt DC power that is capable of supplying
10 amps of current even when other equipment is operating. For best results, run two
new wires from the red (
+
) positive and black (
−
) negative power wires of the light
directly to the main 12 volt DC accessory panel. Install fuse and fuse holders as shown
in diagram. A 10 amp circuit breaker can be installed instead of an in-line 10 amp fuse.
If the light will be less than 30 feet (9m) from its power source, use 12 gauge (3mm)
power supply wires. If the distance will be more than 30 feet (9m), use 10 gauge (5mm)
wires.
Complete the wiring connections as shown below:
Operation
Foam Gasket
10-12 ga. Butt Connector
10 Amp Fuse
(or circuit breaker)
Black
12 volts DC
Red
12 volts DC
Weather-proof
phone wire splice
or soldered connection
18-22 ga. Butt Connector
Black
12 volts DC
Red
12 volts DC
2 Amp
Fuse
“CONTROL”
white wires
