GUDEL ZP 3-5 V4, Operating Manual

Page: 201 / 354

Replace the roller as follows:
Prerequisite:The roller has been relieved
1 Switch off the system and padlock it to secure it against being switched
on again
2 Remove screws B and wiper and lubrication unit
3 Remove the fastening screw and serrated lock washer
4 Remove the screws I from the flange
5 Remove the flange from the carriage using the extractor:
5.1 Screw in screw K into thread of the flange through hole of extrac-
tor
5.2 Screw in screw K and remove flange from carriage
5.3 Remove screw K, extractor and flange
6 Remove and replace roller
7 Replace serrated lock washer
8 Install the flange on the carriage using screws I
9 Install roller in flange using fastening screw and serrated lock washer
10 Tighten screws I and fastening screw
The roller has been replaced.
Replacing the double roller
WARNING
Unexpected movement of carriage and axis
Simultaneous replacement of several rollers may lead to unexpected move-
ment of carriage or axis. This can lead to severe or fatal injuries!
• Replace the rollers individually
Adjusting washers may be located under the screws. During assembly, reuse
them for the same screw threads.
Maintenance OPERATING MANUAL ZP 3-5 V4
72057594174110603_v5.0_
EN-US
201