Gude Expert Power Control 1100, Manual

Page: 17 / 23

17
Expert Power Control 1100/1101 Configuration
4.3.9.5 Enable Authentifiaction
If your e-mail server needs an authentification, you can enter it here.
4.3.9.6 Username
Enter the username, the device should use to log on your e-mail server.
4.3.9.7 Set new password
If your server needs a password for sending e-mails, you can enter it here.
4.3.9.8 Repeat password
Repeat the password, to enable it.
5 Operation
5.1
Switching at the device
To switch the Power Port press the button right of the RJ45 socket for 2 seconds.
You can see the state of the Power Port from the color of the (on/off) LED at the front (green = on / red = off).
5.2
Switching by Webinterface
Go to the website of Expert Power Control 1100/1101. Enter the IP address of Expert Power Control 1100/1101 into the
address line of your internet browser:
http://”IP address of Expert Power Control 1100/1101”/ and press LOGIN
5.2.1 Control Panel
In the Control Panel, you can turn on the power port directly. The exact switching functions are subsequently
described.
The Control Panel also shows the Energy Measurement values and if the sensor is connected. There you can reset the
Relative Energy counter when you press the reset button. The Total energy meter will show its values counting from the first
start.
The Min / Max values of the sensors can also be reset via the "Reset min/max" button.