GÜDE 94081, Manual, Page: 40 / 267

GB
•
Always move forward only at work .
•
Working on slopes, advance across, never up and down. Be very careful when changing the
direction .
•
The blades should not be running when ungrassy areas are crossed and when moving from a site
to another one.
Refine soil already spud !
6.4.4 Bush Shears Operating Instructions
•
Use the unit only after you have read the instruction manual carefully .
•
Observe all the safety instructions contained in the manual .
•
Hedge scissors may be used not only on hedges but also to cut shrubs. .
•
The best cutting output may be obtained when the scissors are conducted at an approximate angle of
15° to the hedge .
•
To obtain an even height of the hedgerow, it is recommended to have a conducting cord stretched
along the hedge. Any branched beyond the line will be cut off. .
•
Side surface area of the hedge will be trimmed by arched movements from down upwards.
6.5 Step-by-Step Instructions
•
Remove any foreign objects from the ground to be treated.
•
Put appropriate protection clothing on .
•
Start the unit according to the description in chapter “Operation”.
•
Observe all the relevant safety instructions .
•
Clean the unit after every use and check all the integrated tools and protection devices for damages.
7 Troubles-Causes-Troubleshooting
Trouble Cause Troubleshooting
The engine will not
start
1. Empty tank
2. The engine is flooded
3. Fouled plug, (the carbon residues
on electrodes) too big distance
between the electrodes.
4. Fouled carburettor or carburettor
jets.
5. Damaged plug connection or
ignition cable.
6. Ignition spark missing
1. fill up the tank
2. Close the throttle, try starting several
times, remove the ignition plug if
necessary and dry it.
3. Clean the plug, check the thermal value
and replace it if necessary
Set 0.6-0.7 mm
4. Clean the carburettor blow it off
5. Replace
6.
Check short-circuit knob, the cable
ignition module and replace if
necessary.
Adjust the gap (0,3-0,4 mm).
When idling, the
engine is too fast
1. Cold engine 11. Heat up slowly, turn down the choke if
necessary .
The engine will not
reach the maximum
output 1. Fouled plug, (the carbon
residues on electrodes) too big
distance between the
electrodes.
2. Fouled carburettor or
carburettor jets.
3. Fouled air filter
4. Exhaust, exhaust pipe
5. The packing ring in the
1. Clean the plug, check the thermal value
and replace it if necessary
Set 0.6-0.7 mm
5. Clean the carburettor blow it off
2. Clean
3. Remove the exhaust pipe, clean and
remove carbon residues.
4. Replace
39