6
1-800-457-3911
Step
3
To Set the Static Correction Level
Read all steps before attempting to set the
Static Correction Level.
1. Remove the clear plastic cover with the Battery
Wrench portion of the Test Light Tool (
2A
) to
expose the Correction Level Button (
2E
).
2. With the battery installed, press the
Correction Level Button and release when
the Receiver LED Indicator Light lights up
(
2F
).
3. The Receiver LED Indicator Light will
emit a series of fl ashes representing the
Static Correction Level.
4. Increase the Static Correction Level by
pressing and releasing the Correction Level
Button within 5 seconds of the previous
series of fl ashes.
5. After setting the Static Correction Level,
2E
2F
replace the cover to protect the Correction Level Button.
The Static Correction levels increase in strength from 1 to 4. Pushing the Correction Level Button while the
Receiver Collar is on level 4 will cause the Receiver Collar to revert to level 1. Refer to the Function and Response
Table to choose the Static Correction level that best fi ts your pet.
The Receiver Indicator Light acts as a low battery indicator, fl ashing every 4 to 5 seconds when replacement is
required.
Function and Response Table
Indicator Light
Response
Static
Correction Level
Receiver Collar Function
Temperament of Pet
1 Flash
1
No Static Correction, Beep Only
2 Flashes
2
Low Static Correction
Timid
3 Flashes
3
Medium Static Correction
Timid or Average
4 Flashes
4
High Static Correction
High Energy
Flashes once every
4 to 5 seconds
Indicates Low Battery
Note: Begin training with Static Correction Level 2 and only increase if your pet does not respond to the Static Correction.
__________________________________________________
Adjust the Pet Area to Desired Size
Make sure the entire Pet Area lies within your property boundaries (
3A
). Always start
determining the Boundary Zone at the shortest distance from Transmitter. Place the
Boundary Switch on “Low” if the Boundary Zone will be less than 45 feet from the
Transmitter.
Two-Person Method
Hold the Receiver Collar at your pet’s neck height (
3B
) with logo side facing away from
the Transmitter (
3C
). Walk to the edge of the desired Pet Area. Facing away from the
Transmitter, hold the Receiver Collar at the edge of the desired Pet Area (
3D
).
Starting with the Boundary Control Dial set to “8”, have a second person turn the dial
down SLOWLY. When the Receiver Collar starts to beep, tell the person to stop turning
the Boundary Control Dial. Record your settings below for future reference.
Pet
Area
STREET
3A
