background image

 
 
Before a wireless RF device is made available for sale to the Public, it must be tested and 
certified to the FCC that is does not exceed the SAR limits established by the FCC. Tests for 
SAR are conducted using the positions and locations (e.g., worn on the body) as required by the 
FCC for each device model. The Mobile1 has been tested and meets the FCC RF exposure 
guidelines when worn on the body using only the approved belt. Other uses may not ensure 
compliance with FCC RF exposure guidelines. 

 

 

WARNING 

The Mobile1 is intended to be worn on the body using the approved belt. Use of any other 

unauthorized method to attach the Mobile1 would be unsafe. Do not wear the device on or 

near your head. The SAR ratings have not been approved for use in this manner. 

 
 
FCC Compliance Statement 

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference; and (2) This device must accept 
any interference received, including interference that may cause undesired operation. 
 
This equipment has been tested and found to comply with the limits pursuant to Part 15 Subpart 
B, Part 22, and Part 24 of the FCC rules. These limits are designed to provide reasonable 
protection against harmful interference in an appropriate installation. This equipment generates, 
uses, and can cause harmful radiation to radio communication. There is no guarantee that 
interference will not occur in a particular use. If the equipment does cause harmful interference 
in radio and television reception, the user is encouraged to try to correct the interference by one 
or more of the following measures: 
 
A. Increase the separation distance between the equipment and the receiver. 
B. Contact GTX Corp Technical Support for assistance at (800) 555-1212.  
 
 

Changes or modifications without the express consent of the manufacturer may void any 
applicable warranty and the user’s authority to operate the equipment. 

 

 
Product Safety Instructions 

 

Please follow all safety instructions outlined below. Failure to follow these instructions may 
result in serious personal injury and/or property damage. 

 
Always obey all applicable regulations in any area where the Mobile1 may be used. Turn your 
Mobile1 off by removing the battery in areas where its use is prohibited or where it may cause 
interference or danger to anyone. 
 
Use of radio equipment is prohibited in hospitals and may interfere with the use of medical 
equipment. Do not use the Mobile1 in Hospitals or near medical equipment. The Health Industry 
Manufacturers Association recommends that a minimum separation of six inches (6”) be 

 

5

Summary of Contents for Mobile1








Reviews: