GTS BG 132, Installation And Operating Manual

Page: 41 / 128

Page 41 Issue 05/2013
Installation of generator
Installation of single-bearing generators
6.6.4.2 Assembly of brush generators
Preparatory disassembly and removal of carbon brush holder
Ö
Fig. 7, Preparatory disassembly for assembling single-bearing brush
generators, page 41
>
Unscrew two M8 x 45 screws, wrench size 10 mm, [2] .
>
Remove the sleeve [1] .
>
Remove both connection lines from the connecting lugs of the carbon
brush holder [4] .
The connection lines are coded by the size of the connecting lugs thus
protecting them against being swapped.
>
Unscrew the mounting screw of the carbon brush holder and remove the
carbon brush holder [4] .
>
Remove the transportation lock (wooden wedge).
>
Remove the fan wheel cover [3] on the generator.
1
2
4
3
Flange shown
rotated by 45°
Fig. 7 Preparatory disassembly for assembling single-bearing brush
generators