31
1
ON
2
3
4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF
120
MIN
MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX
OUT
SOLAR
PANEL
18VAC
RECR
GRN
BL
K
RED
EXIT
SAFET
Y
EDGE
CY
CL
E
COMMON
LINK
Wiring Driveway Loops
to the Mighty Mule 350
Wire from LOOP
V+
to AUX OUT (+)
COM
and
V–
to COMMON
NO
to EXIT
ON
1 2 3 4 5 6 7 8 9 10
DIP
NO COM NC V
+
V
–
LO
OP
LO
OP
Wire
Nut
W
eather proof junction bo
x
to house
LO
OP Controller
Mighty Mule Free Entry/Exit Loop
A Free Entry/Exit Loop is a in ground wire loop that senses a vehicle as it drives over it and opens the gate. It
can be placed in the driveway outside the gate to allow FREE Entry to the property and it can be placed in the
driveway inside the gate to allow FREE Exit from the property.
Depending on how you want your gate to function you can use just one or all types on the same gate.
Make sure the power switch to the opener is turned OFF before
connecting loop wiring to the Mighty Mule 350 terminal blocks.
The LOOP Controller must be placed in a weather proof housing separate from the opener arm.
Use 16 gauge multi-stranded low voltage wire to connect the LOOP Controller to the Mighty Mule 350 control
board.
Connect a wire from the V+ terminal on the LOOP Controller to the AUX OUT (+) terminal on the Mighty
Mule® 350 control board. Connect a wire Connect a wire from the NO (Normally Open) terminal on the LOOP
controller to the EXIT terminal on the Mighty Mule 350 control board. Connect wires from the V– and COM
terminals on the LOOP controller to the COMMON terminal on the Mighty Mule 350 control board. The twisted
pairs of wires from the ground loop are then connected to the LOOP terminals on the LOOP Controller. See
Illustration below.
