GTO 2000XLS Instruction Manual © 02.07.12
13
Step 4
Connecting the Battery
Verify that the ON/OFF switch is in the OFF position.
Connect the BATTERY WIRE HARNESS wires to
the battery — RED wires to POSITIVE (+) battery
terminal and BLACK wires to NEGATIVE (–) battery
terminal.
The BATTERY WIRES from the CONTROL BOARD
should extend through the KNOCK-OUT in the
back of the CONTROL BOX. Plug the BATTERY
HARNESS wires into the wires coming from the
CONTROL BOX.
Step 5
Tuck the excess battery leads into the battery box
and reattach the CONTROL BOX to the BATTERY
BOX
Step 6
Remove the Control Box Cover
Remove the four (4) control box cover screws
and remove the cover to access the CONTROL
BOARD.
Step 7
Attach antenna to
control box cover. First,
remove the Phillips screw
(labeled ANT) from the
control box cover. Place
one end of the antenna
coil over the antenna
plug (antenna wire will fit
into groove). Tighten the
Phillips screw to secure
antenna.
Connecting the Battery Box / Control Box
Battery
Back of
Control Box
Battery Wire Harness
with In-Line Fuse
Battery Box
Control Box
Control Box Cover
Control Board
