Page 18
Installing Optional Modules
Fitting Proximity or Card Swipe Reader Modules
Note:
Proximity and card swipe readers use the same mounting location, only one internal module may
be fitted to the GT8 at the same time. When fitting swipe card readers ensure the reader head is located
correctly in the aperture at the bottom of the GT8 before fully securing using the screws supplied.
RM-MAG-B
RM-BAR-B
RM-HID-B
Proximity Reader & Card Swipe
Mounting Position
Fixing screws
RM-HID-B in position with fingerprint reader fitted.
1.
Remove lower cover.
2.
Position proximity/card swipe module and
secure with screws provided (do not over
tighten).
3.
Connect ribbon cable to connector on
PCBA, circled right.
4.
Replace lower cover (do not over tighten
screws).
Note:
To avoid undue stress on the cables,
the ribbon cable should pass underneath the
fingerprint USB cable (when fitted).
