www.globetechinnovations.com
13
Remote control
The remote control works in a single channel mode. It has four
buttons. See Fig.12 Remote transmitter. The function of button
1, button 2
、
button3 are the same and button 4 is pedestrian
mode. With each press of the remote control button (1, 2 and 3)
which has been programmed, the gate will close, stop, open or
stop cycle.
Remote Pedestrian button: After you learn the transmitter, you
press the remote button 4 the door will open 1 meter when the door
is closed.
You can program/learn button 1, button 2, and button 3
individually. If you learn button1, the button 1 and button 4 are
enable, if you learn button 2 too, the button 2 and button 4 are
enable, the button 1 is disable.
Button 1
Button 2
Button 3
Button 4
Fig.12
Remote transmitter
Adding extra remote controls (Learn):
Remove the cover, press
and hold the learn button
‘S1’ (Fig.8) more than 2 seconds, then
the
‘LED of LEARN’ (Fig.8) will be on, then press the remote
control button which you want to use, the
‘LED’ will turn on about
2 seconds and then turn off again. The learning process is
finished.
Up to 25 remote controls may be used.
Erase remote controls: To erase all existing remote controls,
press and hold learn button
‘S1’, the LED of ‘LEARN’ will turns
