16.
6. Turn battery switch ON.
7. Push and hold the engine start push button for 1
second and release (see Figure 7). The engine will
automatically set the choke and begin the start
sequence.
Figure 7: Electric Start Button - PUSH
8. Plug in electronic devices.
NOTE:
If the engine fails to start after 5 seconds,
release button and let generator sit idle for 15
seconds, then repeat step 7. If cranking speed drops
after each unsuccessful attempt, then battery may not
be adequately charged.
Manual Start
1. Check oil levels (see Adding Engine Oil on page 14)
2. Make sure nothing is plugged into any of the
outlets.
3. Make sure battery is connected (see Installing
the Battery on page 14).
4. Make sure the circuit breakers are properly set.
Figure 8: Pull the Recoil Handle out from generator
Wireless Remote Start
1. Check oil levels (see Adding Engine Oil page 14)
2. Battery must be connected for auto choke to work.
3. Make sure the circuit breakers are properly set.
4. Confirm that the Fuel Control Switch is in the ON
position (see Figure 6).
5. Push the START icon on the wireless remote. (see
Figure 9).
Figure 9: Wireless Remote - START
START
STOP
5. Turn the Fuel Control Switch to the ON position
(see Figure 6).
6. Turn the battery switch ON.
7. Firmly grasp and pull the recoil handle slowly until
you feel increased resistance. At this point, apply
a rapid pull while pulling out from the generator
(see Figure 8).
8. Plug in electronic devices.
www.gtpower.co.nz
Summary of Contents for GT4000ESi
Page 1: ......
Page 5: ...5 www gtpower co nz ...
Page 6: ...6 www gtpower co nz ...
Page 30: ...Wiring Diagram 30 3 6 8 1 2 4 5 7 9 10 黑白色 黄色 紫色 www gtpower co nz ...
