Switch Double Style Wireless
Controller Specification
File
：
Date
：
2021/2/2
Version
：
A259 A3
7
Controller built in 3.7V/500mAH lithium battery which can repeat charge.
The charging time is about 3 hours and the usage time can up to 8 hours after full-charged.
Remarks: The above charging time and usage time data are for reference only.
Ⅷ
.Device name on different modes
PC DINPUT:
DOUBLE STYLE CONTROLLER
PC XINPUT: Device name shows Xbox 360 Controller for Windows
NO.
Item
Standard Parameter
1
Rated Voltage
3.7V
2
Rated Capability
500mAh
3
Internal Impedance
≤
180mΩ
4
Charge Limit Voltage
4.20±0.05V
5
Discharge Limit Voltage
3.0±0.05V
6
Overcharge Detection Voltage
4.275
±
0.025V
7
Overcharge Release Voltage
4.175
-0.025
V
8
Discharge Limit voltage
3.0
±
0.05V
9
Over-discharge Detection Voltage
2.95
±
0.08V
10
Over-discharge Release Voltage
3.05
±
0.05V
11
Over-current Detection value
2.0
±
0.2A
12
Battery size
9.0*20*30
MM Cable Length 35MM
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
