Page 2 of 4
Model:
MPPT12-1
200W Solar Charger
Maximum Power Point Tracker
Operating Instructions
Please read these instructions before use
Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia
Basic Wiring Instructions:
MPPT12-1 General Information:
•
This MPPT is designed to auto detect 12V and 24V battery systems and select a suitable
charge regime.
or 24V batteries respectively.
•
The absorption phase is entered following a low battery condition and is maintained for
approx. 1.5 hours.
.
•
This MPPT has a built in multilevel over temperature protection to improve product reliability
while maximising output power availability.
•
The peak maximum output power is 250W and the continuous output power is 150W on 12V
systems and 200W on 24V.
over 20%.
•
The fuse PVF can be replaced by a suitably heatsinked 20A 60V schottky diode ( its anode
connected to the + panel and cathode to the MPPT white wire). This diode will avoid a small
drain during night time (approx. 0.04A ) as well as protect against panel short but it will also
slightly decrease the battery charge current.
Note:
First start up may take up to one minute.
MPPT12-1-R5
