GSi PNEG-1429, Assembly And Operation Manual

Page: 27 / 46

PNEG-1429 Horizontal Drive Units 27
6. Start-up
Perform Pre-start Checks
1. Make sure ALL belts are tensioned properly.
2. Make sure ALL shields are in place and that the belt(s) and pulley(s) are able to move freely.
3. Inspect the drive unit for any problems or potential problems.
4. Be aware of any emergency shut down procedures. Two (2) people must always be in a position
where the operation of the equipment can be monitored.
5. Before starting the auger for the first time, make sure that all parts are assembled correctly
according to the instructions in this manual.
Failure to perform any or all of these pre-start checks may cause damage to the
equipment and/or cause SERIOUS INJURY or DEATH to those in the work area.
Failure to perform any or all of these pre-start checks may also be a misuse of the
equipment. Any misuse of the equipment may void the warranty.
ALWAYS keep ALL guards and shields in place until all the power is disconnected
and locked out.
Make certain ONLY trained operators are in the work area before operating or
moving the machine. Two (2) people must always be in a position where the
operation of the equipment can be monitored.