30" - 36" Platform Assembly
17
PNEG-1295
16" - 36" Platforms
RIGHT HAND DRIVE SETUP
LEFT HAND DRIVE SETUP
Fasten decking weldment floor section to the
two support channels with 3/8" x 1" bolts and
whiz nuts. Attach the two vertical support
angles to the rear of the head angles using
1/2" x 1" bolts and nuts. Attach the other end
to the support channel using 3/8" x 1" bolts and
whiz nuts. Place outside floor sections on
Figure 8-A
Figure 8-B
4
Deck Channel
Support Angle
(HSP36014)
3
Outside
Decking Drive
Weldment
(HSP30112)
1
Decking
Weldment
(HSP30107)
2
Outside
Decking
Access
Weldment
(HSP30117)
4
Deck Channel
Support Angle
(HSP36014)
1
Decking
Weldment
(HSP30107)
2
Outside
Decking
Access
Weldment
(HSP30117)
3
Outside
Decking
Drive
Weldment
(HSP30112)
Floor Sections
support channels in location shown below and
fasten to support channels and decking weldment
using 3/8" x 1" bolts and whiz nuts, for right hand
drive see Fig. 8-A, for left hand drive see
Fig. 8-B. Make sure not to tighten the hardware
until assembly is complete.
