GSI Group 890-00584, Installation And Configuration Manual

Page: 67 / 120

10
Configuring a 4 - 20mA Zone
Type
Topics Covered in this Chapter
▪ Naming the Zone with a Text Label
▪ Selecting a Partition
▪ Selecting a Module
▪ Selecting an Input
▪ Selecting a Zone Type
▪ Setting the Alert Recognition Time
▪ Setting the Alert Recovery Time
▪ Resetting the Daily Minimum and Maximum
▪ Selecting the Unit of Measure
▪ Entering the Minimum and Maximum Values for an Input
▪ Activating a device in the Event of an Alert or Trouble
▪ Receiving a Phone Call When an Alert is Active
▪ Receiving an E-mail When an Alert is Active
▪ Enabling the Siren
▪ Enabling the Internal Speaker
▪ Recording the Zone Audio Label
▪ Calibrating the Sensor Outputs
▪ Setting the Calibration Zero and Calibration Span
▪ How it Works: Calibration Zero and Calibration Span
▪ Viewing Zone Calibration
Naming the Zone with a Text Label
The zone text label is a name you give to a zone to facilitate its identification. In addition to the zone
number, the text label appears everywhere where the zone is identified in writing on the user interface.
1. In edit mode, under the General tab of the zone you are configuring, click on the edit field next to the
Name button.
2. Type in the zone label of your choice.
NOTE: The field is limited to 32 characters.
Selecting a Partition
Partitions are used to group zones that are located in the same area or that are logically connected
together. This can represent entire buildings or portions of a building. If you select the same partition in the
zones belonging to a specific area, monitoring is done with one partition instead of several zones. Zones in
a partition can also be bypassed and activated collectively.
What You Should Know
895-00677 Agri Alert 128 Touch 67