GSI Group 890-00584, Installation And Configuration Manual

Page: 68 / 120

Chapter 10: Configuring a 4 - 20mA Zone Type
NOTE: In order to be available for assignment, a partition must be created.
1. In edit mode, Under the General tab, click on the edit field next to Partition.
2. Click in the circle to the left of the partition of your choice.
Figure 10-1 Example of a partition
BUILDING 1
AGRI-ALERT
PARTITION 1
PARTITION 2
ZONE 1 ZONE 2
ZONE 3
ZONE 5
ZONE 4
ZONE 6
ROOM 1
ROOM 1 ROOM 2
ROOM 3 ROOM 4
ROOM 2
BUILDING 2
Selecting a Module
By selecting a module you link the zone to the area you want to monitor.
1. In edit mode, under the General tab, click on the Module edit field to display the selection box.
2. Select a module from the list.
NOTE: Only the modules that are connected to the system and that are initialized in the system are
available for selection.
Selecting an Input
1. In edit mode, under the General tab, click on the Input edit field to display the selection box.
2. Select the input from the list.
Selecting a Zone Type
Selecting a zone type allows the system to properly interpret the data received from the selected input
What You Should Know
IMPORTANT: The selected zone type must correspond to the type of sensor associated with the input you
selected.
1. In edit mode, under the General tab, click on the Type edit field to display the selection box.
2. Select a zone type from the list. Once a zone type has been selected, the configuration page displays
the appropriate settings.
68 895-00677 Agri Alert 128 Touch