RESET button
• If, due to external interferences (caused by static charges of
carpets, thunderstorms, etc.), the control electronics of your
Yacht Boy 360 should receive bad information signals, or if
no entries at all are possible, press the
RESET
button. For
pushing this button, it is best to use a bent-up paper clip.
– This releases the RESET impulse which in turn resets the
unit to its initial programming state.
– The stored data for the individual station memory positions,
the clock time and the Last Station Memory is cleared.
When the power supply is interrupted, the stored stations
and menu options are retained for approx. 30 minutes.
GENERAL
For convenient operation, your Yacht Boy can be
brought into a tilted position by the swing-out stand
provided at its rear.
The type plate is to be found below this stand.
On the stand, there is an illustration showing the time zones of
the world.
Button pressure times
Brief: less than 0.5 seconds
Long: more than 0.5 seconds
Switching on and off, Locking
• To switch the unit on and off, press the
POWER
button
(with the
LOCK
not being activated, see below).
Locking
• With the unit being switched on or off, you can lock the
function buttons at the front of the unit by pressing the
LOCK
button.
The buttons are
thus protected
against inadvertent
operation (indication
LOCK
in display).
• To unlock the
buttons, press the
LOCK
button once again.
Direct entries
• For entering numeric values, use the
numeric buttons
.
These values are:
– – Frequencies
– Station positions numbers (programming and calling up)
– SW meter bands
– Clock times
– Switching times.
• For each data entry (pressure on a button), you dispose of
up to approx. 5 seconds. When this time has elapsed, you
must re-enter the whole numeric value.
• To immediately correct bad entries which have not yet been
concluded, press the
FM
or
AM
button, or press twice the
'
.
' button (decimal point) of the numeric buttons.
– If you should make a bad entry or operation, the error
message
Error
will appear in the display.
Display Illumination
• Pressing the
LIGHT
button switches on the display
illumination for approx. 10 seconds.
• If you press a button of the unit, this illumination time will
be increased.
• If you wish to immediately switch off the display
illumination, press the
LIGHT
button once again.
Volume and Tone
• The volume is adjusted with the
VOLUME
control
• The tone is adjusted with the
TONE
switch:
LOW = Bass
HIGH = Treble.
Waveband Selection
After switching on the unit with the
POWER
button, it is ready
for reception and you hear the station last tuned to.
FM
• The FM (VHF) band is selected with the
FM
button.
AM
• The AM bands are selected with the
AM
button.
• The first pressure on the
AM
button switches to the station
last received on one of the AM bands.
• Each further pressure on the
AM
button steps through the AM
bands in the order LW -> MW -> SW -> LW -> MW -> etc.
and you will hear the station last tuned to in the selected
band.
TIME I
LOCK
MHz
ɷ
ɳ
FM
0 … 1 … 2 … 3 … . 4 … 5
TUNING
General operation
YB360 page 15
15
GB
Summary of Contents for Yacht Boy 360
Page 1: ...YB360 page 1 YACHT BOY 360...
