Grundig GML-2230M, Owner'S Manual

Page: 10 / 14

Swap:
Press – or + to to swap the windows of the Main and Sub Source.
NOTE:
1. In PIP / POP mode, AV1 or AV2 and HDMI or VGA can be displayed at the same time
on one monitor.
2. If POP mode is selected, both images are scaled to fit the screen.
8. Frequently Asked Questions
The Power button does not respond:
- Check the power cord to ensure that it is securely plugged into the monitor base and
also into the electrical outlet.
- Ensure that there is electrical power coming from the AC outlet. Use another device to
check the power.
- Unplug the power cord of the monitor from the AC outlet, wait a few minutes, then plug
the power cord into the AC outlet again. This will reset the monitor and power supply.
No image on the screen:
- Ensure that the DB-15 signal cable is properly connected to the display card/computer.
- Check the DB-15 signal cable connector on both ends for bent or pushed-in pins.
- The display card should be properly seated in its card slot.
- Ensure that the computer's power switch is ON.
- Ensure that the monitor's power switch is ON.
- Unplug the power cord of the monitor from the AC outlet, wait a few minutes, then plug
the power cord into the AC outlet again. This will reset the monitor and power supply.
The Power LED is red (with no image on the screen):
- Check the DB-15 signal cable to ensure that it is properly attached to the graphics
display card.
- Check the DB-15 signal cable on both ends for bent or pushed-in pins.
- Make sure the computer is not in a power-saving mode (move the mouse or press a
key on the keyboard).
8 English