Grundig GCI-F0505B, Owner'S Manual

Page: 49 / 101

Triggered Action (Multi-option) :
The Administrator can specify alarm actions that will take place when the alarm is triggered. All options are
listed as follows:
- Enable Alarm Output:
Select this item to enable alarm relay output.
- IR Cut Filter:
If you select this item, the camera’s IR cut filter (ICR) will be removed (on) or blocked (off) when the alarm input is
triggered.
NOTE: The IR Function (Refer to IR Function) cannot be set to <Auto> mode when this trigger action is enabled.
NOTE: The IR Cut Filter is not available for the camera GCI-K1603B.
- Send Alarm Message by FTP:
The Administrator can choose to send an alarm message by FTP when an alarm is detected.
- Send Alarm Message by E-Mail:
The Administrator can choose to send an alarm message by E-Mail when an alarm is triggered.
- Upload Image by FTP:
After selecting this item, the Administrator can assign a FTP site and configure various parameters as shown in
the figure below. When the alarm is triggered, event images will be uploaded to the appointed FTP site.
47 English