65
ENGLISH
SpECIAL SETTINGS
----------------------------------------------------------------------------------------------------------
Note:
7
You can abort the search by pressing »
i
«.
9
Press »
i
« to end the setting.
Searching for digital terrestrial
TV channels manually
1
Open the menu with »
i
«.
2
Select the line »SOURCE SETUP« with »
V
«
or »
Λ
« and press »
●
« to confirm.
– The »SOURCE SETUP« menu appears.
3
Select the line »Source« with »
V
« or »
Λ
«
and press »
●
« to confirm.
Select the option »Air« with »
<
«, »
>
«, »
V
« or
»
Λ
« and press »
●
« to confirm.
Caution:
7
The antenna power supply (line »Active
Antenna Power«) may only be switched on
if the antenna is an active indoor antenna
with a signal amplifier and it is not already
supplied with a voltage via a mains plug
(or similar supply). Otherwise you may
cause a short circuit and irreparably dam-
age your antenna.
4
Select the »Active Antenna Power«« with »
V
«
or »
Λ
«. Switch on the antenna power supply
for the antenna with »
<
« or »
>
« (»On«).
5
Select » Digital Manual Tuning« with »
V
« or
»
Λ
« and press »
●
« to confirm.
– The menu appears.
6
Enter the channel number directly with
»
1 ... 0
« and press »
●
« to confirm.
– After the search is complete, the channels
found are displayed in the »Results« menu.
7
Press »
i
« to finish the setting.
Tuning analogue television
channels
This setting is only necessary if you cannot re-
ceive any digital channels and you have not car-
ried out an analogue search during initial setup.
The television channels can be set directly or
using the scan.
Switching the television to
analogue reception
Note:
7
Analogue channels can be selected if the
option »Air« or »Cable« has been selected.
1
Open the »Select input source« menu with
»
AV
«.
2
Depending on the antenna system, select the
option »Air« or »Cable« with »
V
«, »
Λ
«, »
<
«
or »
>
« as the input source and press
»
●
« to
confirm.
Note:
7
Additional operations are explained in the
following sections.
Setting all analogue television
channels
Analogue channels are displayed in the channel
list after the digital channels.
Note:
7
Plug the rooftop antenna cable (for analogue
television channels) into the »
ANT IN
«
socket on the television.
1
Open the menu with »
i
«.
2
Select the line »SOURCE SETUP« with »
V
«
or »
Λ
« and press »
●
« to confirm.
– The »SOURCE SETUP« menu appears.
3
Select the line »Source« with »
V
« or »
Λ
«
and press »
●
« to confirm.
Select the option »Air« or »Cable« with »
<
«,
»
>
«, »
V
« or »
Λ
« and press »
●
« to confirm.
4
Select the line »Automatic Channel Search«
with »
V
« or »
Λ
« and press »
●
« to confirm.
