ENGLISH
16
6
Select the line »DISEqC Mode« with »
v
«
or »
Λ
«.
Select »DiSEqC 1.0« or »DiSEqC 1.1« in
accordance with the existing antenna system
with »
<
« or »
>
«.
– DiSEqC 1.0 allows up to four satellites to
be received simultaneously.
– DiSEqC 1.1 allows up to 16 satellites to be
received simultaneously.
7
Select the line »LNB Selection« with »
v
« or
»
Λ
«.
Select the setting for the respective satellites
with »
<
« or »
>
«.
8
Once the settings for the satellite have been
made, switch to the »AUTOMATIC CHAN-
NEL SEARCH« menu with »
« (red).
Select Satellite
Operator Selection
ASTRA 19.2°,E
Other
Service Type
All
Scan Mode
Free + Scramble
Network Search
Off
Connection Type
Satellite
Exit
Back
SOURCE SETUP
AUTOMATIC CHANNEL SEARCH
Start Search
08.08.2012
15:46
9
Select the line »Scan Mode« with »
v
«
or »
Λ
«.
Select the scan mode with »
<
« or »
>
«
(for unencrypted channels, for encrypted
channels only, or for both).
10
Select the line »Service Type« with »
v
«
or »
Λ
«.
Use »
<
« or »
>
« to select whether you want to
search for television channels only (TV), radio
stations only (Radio) or both (Radio + TV).
Note:
7
It is possible, that some TV channels (tran-
sponders) cannot be found. This is caused
by a change in satellite parameters made
by the broadcaster, e.g. new channels have
been added. Set the »Network Search« op-
tion to »On«.
11
Start the scan with »
« (red).
– The »Results« menu appears, and the scan
for TV channels begins.
– Depending on the number of television
channels received, this can easily take a
few minutes.
– The scan is complete as soon as the »PRO-
GRAM TABLE« appears.
Note:
7
You can abort the scan by pressing
»
mENu
«.
12
Press »
mENu
« to end the setting.
Note:
7
If other television channels are to be tuned
from a second satellite, proceed as follows:
Open the menu with »
mENu
«, select the
line »SOURCE SETUP« with »
v
« or »
Λ
«
and press »
oK
« to confirm. Then select the
»Automatic Channel Search« with »
v
« or
»
Λ
« and press »
oK
« to confirm. Confirm
the line »Select Satellite« with »
oK
« and
select the preferred satellite with »
v
«, »
Λ
«,
»
<
« or »
>
«. Start the scan with »
« (red).
Continue the adjustment by step
7
of the
chapter.
Note:
7
Before recording HD channels, please
check signal quality and Strength, see
chapter "Displaying signal information" on
page 89. If the level is displayed in green,
you can record HD channels without any
problems.
SEttINGS
-----------------------------------------------------------------------------------------------------------------------------------------
