Grundig 40 VLE 8160 BL, User Manual

Page: 72 / 82

­73
ENGLISH
SpECIAL­SEttINGS
­----------------------------------------------------------------------------------------------------------
Searching­for­digital­terrestrial­
tv­channels­automatically
1
Open the menu with »
mENu
«.
2 Select the line »SOURCE SETUP« with »
v
«
or »
Λ
« and press » oK « to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
v
«
or »
Λ
« and press » oK « to confirm.
Select the option »Air« with »
<
«, »
>
«, »
v
« or
»
Λ
« and press » oK « to confirm.
Caution:
7
The antenna power supply (line »Active
Antenna Power«) may only be switched on
if the antenna is an active indoor antenna
with a signal amplifier and it is not already
supplied with a voltage via a mains plug
(or similar supply). Otherwise you may
cause a short circuit and irreparably dam-
age your antenna.
4 Select the »Active Antenna Power« with »
v
«
or »
Λ
«. Switch on the antenna power supply
for the antenna with »
<
« or »
>
« (»On«).
5 Select the line »Automatic Channel Search«
with »
v
« or »
Λ
« and press » oK « to confirm.
– The menu appears.
Exit
Back
SOURCE SETUP
AUTOMATIC CHANNEL
SEARCH
20.09.2010
15:46
Start Search
Scan Type
Country
Connection Type
U.K.
Air
ATV & DTV
6
Select the line »Scan Typ« with »
v
« or »
Λ
«
and set the option »DTV« with »
<
« or »
>
«.
7 Start the scan with »

« (red).
– All channel and favourites lists will be
deleted and compiled anew.
Note:
7
After starting the scan, a security query will
appear. Press »

« (green) to confirm the
option »Yes«.
– The »Reults« menu appears, and the scan
for TV channels begins. Depending on the
number of television channels received,
this can easily take a few minutes.
– The scan is complete as soon as the
»PROGRAM TABLE« appears.
Note:
7
You can abort the search by pressing
»
mENu
«.
8 Press » mENu « to end the setting.
Automatic­service­update­
If this function is activated, possible changes of
network operators are updated automatically.
The unit must be located in stand-by mode.
1 Open the menu with » mENu «.
2 Select the line »SOURCE SETUP« with »
v
«
or »
Λ
« and press » oK « to confirm.
3 Select the line »Automatic Service Update«
with »
v
« or »
Λ
«.
4 Select the automatic update with »
<
« or »
>
«
(»On«).
5 Press » mENu « to end setting.