5.7.5 User-defined functions
This display shows all functions (up to eight) defined by the user.
Each user-defined function is shown with two sources and the
selected functions. To the right of each user-defined function, the
actual status is shown (Active/Not active). See section about user-
defined functions.
Example
The user-defined function named "Run ventilation" has been
activated by the 1st source, which has been set to "Constantly
high". The 2nd source has been set to "DI1 (CU 362) [10]" and is
also active. This means that the ventilator is running.
"Run ventilation" is linked to a digital output. See section about
digital outputs.
Path:
Status > Electrical overview > User-defined functions
1-10-5_USER_DEFINED_FUNCTIONS_130
User-defined functions
Related information
5.8 Overview of all pumps
This display shows the actual overview of all pumps in the system.
The display is a screen saver which is active when the system is
running. This display makes it easy to get all operational data
without pressing any button.
The data applies to all pumps in the system:
•
Pumps running (shown as graphics in the display)
•
Pumps stopped (shown as graphics in the display)
•
Pumps out of operation (shown as graphics in the display)
•
Operating hours yesterday
•
Operating hours
•
Number of starts
•
Number of starts/hour
•
Average current (sensor required)
•
Average flow (sensor or calculation required)
•
Total energy consumption (sensor required).
Example
Pumps 1 and 2 are stopped, pump 3 is running, and pump 4 has
been taken out of operation.
Pump 2 was in operation for 40 minutes yesterday, has been
running for 83 hours and 22 minutes in total, was started 632 times,
etc.
Path:
Status > Overview of all pumps
1-1
1_PUMP_OVER
VIEW_149
Overview of all pumps
6. The "Operation" menu
This menu contains the most common pit settings, such as start
and stop levels, direct pump control (Auto/On/Off), resetting alarm
relays and cancelling interlock.
Example
Select submenu:
•
Auto/On/Off
•
Start and stop levels
•
Out of operation
•
Resetting alarm relays
•
Cancelling interlock
•
Empty pit.
Path:
Operation
TM077334
Operation
Related information
6.1 Auto/On/Off pump control
This display is used to change between operating functions.
"Auto" is used to control the pump automatically.
"On" and "Off" are used to manually start or stop the pump. These
settings can, for example, be used for testing pumps or for forced
draining.
Example
Select the function to be changed.
This dialogue box appears:
"You are about to start or stop the pump. Do you want to
continue?".
Select "Continue" or "Cancel", and press [OK].
Pump 1
Possible settings:
14
English (GB)
