English (GB)
7
8.5 Installation in wall housing
The plastic housing is designed for the
Conex DIS-2Q controller and is very easy to install
and service.
– 300-115 (91835231) for one Conex DIS-2Q
controller
– 300-114 (95709720) for one Conex DIS-2Q
controller with RS-485 interface.
Technical data
1. Loosen the four fastening screws of the front
panel.
2. Remove the front panel.
3. Insert the device from the front.
4. Hook the clamps into the tightening cones on the
sides at the top and bottom.
5. Secure the device from the rear using a
screwdriver.
6. When the front panel is mounted, plug the device
onto the base plate.
7. Screw the front panel into the wall housing.
9. Electrical connection
1. Connect the cables used to the terminals
according to the Conex DIS-2Q terminal
assignment.
Material
ABS
Enclosure class
IP65
Complete with four cable glands
Warning
Switch off the power supply before
installing!
Caution
Enclosure class IP65 is only
guaranteed if the transparent cover is
closed and the appropriate cable
glands or dummy caps are fitted.
Warning
Disconnect the mains voltage before
connecting the power supply cable and
the relay contacts!
Observe the local safety regulations!
Protect the cable connections and
plugs against corrosion and humidity.
Caution
Before connecting the power supply
cable:
Check that the mains voltage specified
on the type plate correlates with the
local conditions!
An incorrect mains voltage may
destroy the device!
Caution
To ensure electromagnetic
compatibility (EMC):
Input and current output cables must
be shielded.
Connect the shielding to the shield
ground on one side.
Refer to the connection diagram! Input,
current output and mains cables must
be in separate cable channels.
Note
Unused terminals remain open.
