8
8. Fitting the cable guard
To fit the cable guard, proceed as follows:
1. Make sure that the motor lead lies flat in the cable
guard.
2. Place the cable guard in the groove in the cable
plug. The two flaps must engage with the upper
edge of the pump sleeve, see fig. 7.
Fig. 7
Placing the cable guard
3. Fasten the cable guard to the pump suction
strainer with the two self-tapping screws sup-
plied, see fig. 8.
Fig. 8
Fitting the cable guard to the pump suction
strainer
9. Piping
• The pump should only be gripped by the two flats
at the top of the pump, see fig. 9.
• The pump can be installed vertically or horizontally.
During operation, the pump must always be com-
pletely submerged in water.
• When plastic pipe is used, a stainless steel safety
wire is recommended for lowering and lifting the
pump. Fasten the wire to the eyelet on the pump,
see fig. 10.
• The threaded joints must be well cut and fit to-
gether tightly to ensure that they do not work
loose.
Fig. 9
Gripping the pump
TM
0
2
9
6
13
3
50
4
TM
01
4427
0299
TM
02 8739
0
8
04
