TROUBLESHOOTING
1– BEFORE STARTING
***** CAUTION : MAKE SURE TO READ AND FOLLOW THESE INSTRUCTIONS
BEFORE STARTING THE TEST.
•
PLUG both output boxes (Zone #1 Output and Zone #2 Output) to the main module using the
2 telephone cables (included)
•
PLUG both remote sensors (Zone #1 Sensor and Zone #2 Sensor) to the main module using
the 2 “Network – CAT5” cables (included, 25-ft each).
•
PLACE both remote sensors close to each other in order to read similar (or equal) CO
2
PPM
levels.
•
CONNECT A LOAD (lamp or fan…) into the CO
2
OUTPUT BOX of ZONE #1 (NOT in the
OUTPUT BOX of ZONE #2).
•
LIGHTING CONDITION: make sure to perform this test in a room with enough light for the
controller to detect a DAY condition. A dark location should be avoided.
2-TEST
STEP
HANDLING AND TEST
DESCRIPTION
EXPECTED RESULTS
1
Plug the external supply into any
120V outlet or power bar, and plug
the power supply connector on the
left side of the module.
VERY IMPORTANT NOTICE :
MAKE SURE TO USE A 12V – 1A
POWER SUPPLY.
The screen shows a 30-second countdown after a short
introduction displaying the name of the product and
the revision number. Wait until the countdown ends.
12
VERY IMPORTANT NOTICE
You MUST use a
12 Volts - 1 Amp.
Power supply.
A 500mA (or 0.5 Amp.) unit
will NOT supply enough power to
the Controller and Sensors.
