GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
20
113836_37_38_39PC Revision date: 06.06.18
Complete the following general steps to install end panels.
1. Consult panel location diagrams and select a panel.
Begin at the edge of door opening and work toward
outside edge of end wall.
See X in diagram below for first panel.
NOTE:
Remove the protective film. When needed, an
upper panel is cut to length
after
attaching it to the end
wall frame and rafter. Use the rafter profile as a guide.
2. Apply vent tape to bottom of lower panel and then
install aluminum u-channel profile (104213) along panel
edge adjacent to door as shown on panel diagram.
3. Place panel in position, attach it to end wall framing
using 102921B neo-bonded washers and long,
FA4484B Tek screws.
Dashed line and small arrows (above) show where to
install vent tape.
X
Mark UV Side
X
NOTE:
When attaching any aluminum profile,
remember to account for areas where different sections
of profile intersect so that profile is cut to proper length.
4. Space FA4484B Tek screws evenly at 16" on-center
when securing panels. DO NOT USE WASHERS
WHEN SECURING H-CHANNEL TO END FRAME.
DO NOT install profile on bottom of end wall panels.
These edges are sealed with vent tape.
Always remove protective film. Mark and install the UV-
protected side to the outside (toward the sun).
GLAZING PANEL
8MM POLYCARBONATE
PANEL SPLICE "H" CHANNEL
TEK SCREW
END WALL FRAME TUBE
END WALL FRAME TUBE
TEK SCREW & NEO-BONDED WASHER
Diagram shows basic panel installation and fasteners used
to secure polycarbonte panels.
Secure all polycarbonat panels as shown in the photo.
Use an FA4484B Tek screw and washer to secure panel to
end wall frame. Do not crush panel when installing screws.