24
Mounting the grinding wheel:
Before any work on the machine itself, pull the mains plug. The tool must be turned off and the spindle
must be at a standstill
For safety reasons, cutting guard must be used when working with cutting wheels.
Make sure that the permissible rotating speed marked on the accessory tool at least matches the rated
speed of the angle grinder.
Check if the wheel is in good condition before using it. Do not use chipped, cracked or any other way
damaged tools.
1.
Lock the spindle (by pressing the spindle lock button - 1 and turn the spindle until it clamps).
2.
Fit the mounting fl ange (4) on the grinder spindle (11). It is mounted properly when there is
no possibility of turning it freely.
3.
Mount the wheel onto the spindle so that it evenly fi ts to the mounting fl ange.
4.
Screw on the clamping nut of the accessory tool (5) to the spindle.
Proper mounting of the clamping nut of the accessory tool:
For thin grinding wheels:
Stop ring of the nut with two holes (5) should be pointing upwards for the thin grinding wheel
to be safely mounted.
For thick grinding wheels:
Stop ring of the nut with two holes (5) should be pointing downwards, so that the nut with
two holes could be safely seated on the spindle.
There is an o-ring inserted in the mounting fl ange (4). If the O-ring is missing or is damaged, it must
in all cases be replaced.
STARTING OPERATION:
Always guide the power tool with both hands.
Switch on the tool fi rst and then place the accessory tool on the workpiece.
Prevent unintentional starting: always switch off the tool after unplugging from the power outlet or
when there is a power cut.
When the continuous work mode is on, the power tool will continue operating even when it falls out
of hands. For this reason, the operator must always hold the power tool by its handles with two hands,
provide for a secure stance and concentrate on work.
Avoid dust or chip emission and sucking them in the power tool. After switching off the power tool, lay
it down only when the engine is fully stopped.
Szlifierki_katowe_Full_v04_HR.indd 24
Szlifierki_katowe_Full_v04_HR.indd 24
2016-10-26 00:19:30
2016-10-26 00:19:30
