![background image](http://html1.mh-extra.com/html/grone-0/2536-481680/2536-481680_operating-instructions-manual_2269668025.webp)
25
STARTING OPERATION:
For safety reasons, the machine is equipped with a Lock-Off switch which cannot be locked in the
continuous work mode.
The operator must press and hold the on/off button for the tool to work.
To switch on the power tool, release the On/Off button lock
switch by pressing it and then press the trigger (11).
To switch of the power tool, simply release the On/Off button
(11). The cutting disc will continue to rotate after switching off
the machine. Make sure that no part of your body touches a ro-
tating disc!
In the case of power cut, the reason for no power supply
must be established before the machine may be switched on again.
An electrical device may be
switched on again only when its safe use may be ensured. Check if the PRCD switch functions
properly.
MAINTENANCE AND CLEANING:
Before carrying out any work on the power tool, the machine must be disconnected from the power
source.
Do not use water or any liquid cleaning agents.
The interior of the body and the engine must be regularly blown off by dry compressed air.
The material/water mixture must be removed directly after the end of work to prevent its
drying and creation of hard coating.
Clean the interior of the protective guard when the diamond cutting disc is being replaced.
11
15
Przecinarka do kamienia_Full_v05_HR.indd 25
Przecinarka do kamienia_Full_v05_HR.indd 25
2016-10-25 21:53:19
2016-10-25 21:53:19