19
4. Power Tool Use and Care
a.
Do not force the power tool. Use the correct power tool for your application. The correct pow-
er tool will do the job better and safer at the rate for which it was designed.
b.
Do not use the power tool if the switch does not turn it on and off . Any power tool that cannot
be controlled with the switch is dangerous and must be repaired.
c.
Disconnect the plug from the power source and/or the battery pack from the power tool be-
fore making any adjustments, changing accessories, or storing power tools. Such preventive
safety measures reduce the risk of starting the power tool accidentally.
d.
Store idle power tools out of the reach of children. Do not allow persons unfamiliar with the
power tool or these instructions to operate the power tool. Power tools are dangerous in the
hands of untrained users.
e.
Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts
and any other condition that may aff ect the power tool’s operation. If damaged, have the
power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g.
Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking
into account the working conditions and the work to be performed. Use of the power tool for
operations diff erent from those intended could result in a hazardous situation.
5. Service
a.
Have your power tool serviced by a qualifi ed repair person using only identical original replace-
ment parts. This will ensure that the safety of the power tool is maintained.
Diamond Cutter-Specifi c Safety Warnings
This power tool is not recommended for polishing.
Operations for which the power tool
was not designed may create a hazard and cause personal injury.
The rated speed of the accessory must be at least equal to the maximum speed marked
on the power tool.
Accessories running faster than their rated speed can break and fl y apart.
The outside diameter and the thickness of your accessory must be within the capacity
rating of your power tool.
Incorrectly sized accessories cannot be adequately guarded or
controlled.
Diamond discs, backing pads, fl anges or any other accessory must properly fi t the spindle
of the power tool.
Accessories with arbor holes that do not match the mounting hardware
of the power tool will run out of balance, vibrate excessively and may cause loss of control.
Do not use a damaged accessory in all cases. Before each use, inspect the accessories, e.g.
diamond discs, for chips and cracks.
If power tool or accessory is dropped, inspect for damage or install an undamaged acces-
sory. After inspecting and installing an accessory, position yourself and bystanders away
from the plane of the rotating accessory and run the power tool at maximum no-load
speed for one minute.
Damaged accessories will normally break apart during this test time.
Wear personal protective equipment. Depending on application, use face shield, safety
goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves
and workshop apron capable of stopping small abrasive or workpiece fragments.
The
eye protection must be capable of stopping fl ying debris generated by various operations. The
dust mask or respirator must be capable of fi ltrating particles generated by your operation.
Prolonged exposure to high intensity noise may cause hearing loss.
Keep bystanders a safe distance away from the work area. Anyone entering the work
area must wear personal protective equipment.
Fragments of workpiece or of a broken
accessory may fl y away and cause injury beyond immediate area of operation.
Hold power tool by insulated gripping surfaces only, when performing an operation
where the cutting accessory may contact hidden wiring or its own cord.
Cutting accessory
Przecinarka do kamienia_Full_v05_HR.indd 19
Przecinarka do kamienia_Full_v05_HR.indd 19
2016-10-25 21:53:18
2016-10-25 21:53:18