6 OM-TA/3
B. INITIAL START-UP
After the mixer is installed, take the following actions to confirm that the
equipment is operating correctly.
1. For a tilting model, tilt the mixer through its complete tilting range to ensure that
there is no hazard or interference.
2. Make sure the agitator is properly coupled with its drive shaft. The mixer agitators
have slip-on couplings. The drive pin of each shaft must be positioned at the end
of the J-slot in the mating coupling. (See photograph at left)
3. Carefully examine the primary agitator to verify that each finger is positioned
correctly as shown in the figure at left.
4. When the mixer is in operating position, the scraper blades should touch the inside
of the kettle during at least part of each revolution of the agitator.
5. At the circuit breaker or fuse box, turn on the electric power supply to the mixer.
6. Switch on the drive and confirm that the mixer operates smoothly throughout its
speed range.
7. Make sure the agitator turns in the correct direction, so it pushes the nylon scraper
blades ahead of the agitator bar.
If the unit functions as described above, it is ready for use. If the unit does not function
as intended, call your local Groen authorized service agency.
For instructions on initial start-up of the kettle component of your cooker/mixer, see
the separate kettle manual.
Installation
WARNING
TURN OFF AGITATOR BEFORE ADDING
INGREDIENTS OR INSPECTING KETTLE
CONTENTS. DO NOT WEAR LOOSE
CLOTHING OR JEWELRY AROUND
OPERATING MIXER KETTLE. KEEP WELL
CLEAR OF ROTATING MIXER ARMS AND
PADDLES AT ALL TIMES.
Slip-on Coupling
Summary of Contents for D - 40/60/80 TA/3
Page 17: ...OM TA 3 17 Wiring Diagram...
Page 19: ......
