OM-CC-E
23
s.
Rinse and wipe down the cooking chamber
with a cloth and plenty of clean water. Rinse
the cloth often.
3.
De-liming Only
If you only want to clean hard, white deposits out of
the steam generator, it is not necessary to degrease
the unit.
a.
Turn off all operating modes by stopping the
timer, and pressing the mode touch pad(s).
b.
Enter 99 on the timer. The display should
show “00:99.”
c.
If the
HOT
light is on, use the Fast Cool
method to reduce the temperature
(Paragraph 5, Operation, Page 18). If the
HOT
light is off, “CI” will be displayed in the
timer window, and you may proceed to the
next step.
d.
Remove all pan racks and clean them in a
sink. To remove the right side rack, lift it up
and to the left.
e.
Pour one pint (two pints for CC-20E) de-
liming agent into the steam generator.
f.
Close the door and press
START
. The timer
will display “CL:50,” with the colon [:]
between the numbers flashing. The timer will
count down to “CL:26.”
WARNING
THE UNIT WILL BE HOT ENOUGH TO CAUSE A
BURN. DO NOT TOUCH ANY HOT SURFACE.
g.
When the buzzer sounds and the timer
displays “C2,” open the door AND CHECK
THE STEAM GENERATOR.
h.
If the generator is free of hard deposits, go
to the next step. If hard, white deposits are
still visible, add de-liming agent again before
proceeding.
i.
Put the generator cover and right side panel
back in place.
j.
Close the door. The timer will display
“CL:26" and count down automatically to
“CL:00.”
k.
Press the
ON
switch to turn off the unit. Let
the unit cool.
WARNING
UNIT MAY BE HOT. DO NOT TOUCH HOT
SURFACES.
l.
Remove the right side panel and steam
generator cover and rinse them thoroughly in
a sink.
m. Rinse and wipe down the cooking chamber
with a cloth and plenty of clean water. Rinse
the cloth often.
n.
Re-install the pan racks.
NOTE:
If the timer stops and the
SERVICE
light
comes on, it means that there have been
errors that prevent the unit from completing
its Clean Cycle. Take the following steps:
1)
Perform a reset. With the unit turned off,
press and hold the
COMBO
touch pad.
Then press the
ON
touch pad to display any
error codes.
2)
If the error numbers displayed are 1
and
3,
or 2
and
3, press
CLEAR
, and restart the
Clean Cycle by entering “99" (00:99) on the
timer. Add one cup of full strength
degreaser and continue the Clean Cycle by
pressing
START
.
3)
If the error numbers are 1
and
2, or 6, call
your authorized Groen Service Agency for
immediate service.
4)
If the error number displayed is 1
or
2, but
not both, the unit may need more cleaning.
If there are other errors, refer to this manual’s
Troubleshooting Section (Page 24)
Clean Cycle Counter
The Convection Combo™ keeps track of
completed Clean Cycles. To see this total, turn
off the unit. Press and hold the 0 touch pad while
turning on the unit. The total will show in the
timer window. It cannot be reset.
3.
Manual Cleaning
This procedure may be necessary if regular cleaning
was not performed.
