-4-
Model T28929 (Mfd. Since 11/18)
8. Remove lock pin from spindle then rotate
drill chuck by hand to test how easily whole
assembly turns.
— If assembly turns with minimal effort, pro-
ceed to
Step 10.
— If assembly does not turn with minimal
effort, proceed to
Step 9.
9. Loosen (2) hex bolts securing notcher base to
frame, rotate spindle, then tighten hex bolts,
then return to
Step 8. Repeat until assembly
turns with minimal effort.
10. Loosen bolts/clamps securing notcher to drill
press table, rotate spindle, then tighten bolts/
clamps. Spindle should turn freely.
11. When notcher is correctly installed on drill
press (see
Figure 12): remove lock pin, apply
cutting fluid, turn drill press
ON, and perform
notching operation.
Hand Drill Operations
Items Needed
Qty
Open-End or Socket Wrench 13mm ................. 1
Hole Saw with
1
⁄
2
" or
5
⁄
8
" Threads ...................... 1
Workbench Mounting Hardware ........ As Needed
Hand Drill ........................................................... 1
Open-End or Socket Wrench 17mm .................. 2
Cutting Fluid ...................................... As Needed
To operate notcher with hand drill:
1. Install hole saw and workpiece on notcher.
2. Mount notcher to workbench using mounting
hardware (not included).
3. Loosen both hex bolts in Figure 13, swivel
base to desired drilling angle, and tighten hex
bolts.
Figure 13. Location of notcher angle hex bolts.
Hex Bolts
Figure 12. Notcher installed on drill press.
Eye injury hazard! Always
wear safety glasses when
using hand drill.
7. Secure base to table with bolts, strap clamps,
or C-clamps (see
Figure 11).
Figure 11. Example of notcher secured to table.
Summary of Contents for T28929
Page 8: ......
