Grizzly T28523, Owner'S Manual

Page: 14 / 32

-12-
Model T28523 (Mfd. Since 05/19)
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figure 5) Qty
A. Grinder (Not Shown) ................................... 1
B. Spark Deflectors ......................................... 2
C. Safety Shields w/Fasteners ........................ 2
D. Safety Shield Bracket (Right) ..................... 1
E. Safety Shield Bracket (Left) ........................ 1
F. Clamping Brackets ..................................... 2
G. Tool Rest Bracket (Right) ........................... 1
H. Tool Rest Bracket (Left) .............................. 1
I. Tool Rest (Left) ........................................... 1
J. Tool Rest (Right) ......................................... 1
Fasteners (Figure 6) Qty
K. Fender Washers 5mm ................................ 2
L. Lock Washers 5mm.................................... 2
M. Flat Washers 6mm ..................................... 4
N. 3-Lobe Knobs M5-.8 .................................. 2
O. Knob Bolts M6-1 x 16 ................................. 2
P. Carriage Bolts M5-.8 x 50 .......................... 2
Q. Hex Bolts M6-1 x 14 ................................... 2
R. Phillips Head Screws M5-.8 x 10
w/Washers .................................................. 4
K
L
N
M
O
P Q R
Figure 6. Fastener inventory.
Figure 5. Tool rest and safety shield parts.
I J
E
F
H
B
C
G
D