-4-
T26413/T26414/T26415 (Mfd. 9/13+)
2. Insert handle through handle hub and re-
install cap, as shown in
Figure 7.
Figure 7. Sliding handle installed.
3. Thread handle lock knob bolt into hub, as
shown in
Figure 7. When tightened, this knob
bolt secures handle in position relative to
hub.
4. Raise ram and insert table plate pin into base
(see
Figure 8).
Figure 8. Table plate and dies.
Table
Plate
Dies
5. Insert included dies in provided storage holes
on base (see
Figure 8).
Table Plate
Rotate table plate to align desired table opening
size under ram (see
Figure 8).
Installing Dies/Tooling
The included dies or custom tooling is inserted
into the ram bore, which has a
1
⁄
2
" diameter,
1
⁄
2
"
depth, and a magnet at the bottom of the bore
to hold the tooling in place (see
Figure 9 for an
example).
Figure 10. Hex bolts that secure front plate.
Hex
Bolts
Front
Plate
Handle
Hub
Flipping Ram
The ram can be flipped end-over-end, depending
whether the solid end or the end with the bore is
needed for the operation.
Tools Needed
Qty
Wrench or Socket 10mm (T26413) .................... 1
Wrench or Socket 12mm (T26414, T26415) ...... 1
To flip the ram:
1. Remove hex bolts shown in Figure 10, then
remove front plate to access ram rack-and-
pinion (see
Figure 11 on next page).
Handle Cap
Re-installed
Handle Lock Knob Bolt
Figure 9. Example photo of die installed in ram.
Die
