Model T10814 (Mfd. Since 5/15)
-17-
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To complete a typical operation, the operator
does the following:
1. Chooses appropriate grinding wheel for oper-
ation and tooling material.
2. Examines grinding wheel for any signs of
damage, then installs wheel.
3. Inserts tooling into collet. The tooling should
not be loose inside collet; it should be a snug
fit.
4. Installs collet assembly in tool holder and
tightens firmly with quill handwheel.
5. Adjusts tilt of tool holder, as necessary, to the
correct angle of desired grind.
6. Adjusts grinding wheel and tool holder posi-
tions with spindle and guide-rod dials (respec-
tively) to prepare for operation.
7. Puts on personal protective equipment.
8. Stands to side of tool grinder and starts
machine.
9. Allows wheel to reach full speed and rotate
for one minute.
10. Feeds tooling into grinding wheel until desired
results are achieved.
11. Stops machine and removes tooling.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
To reduce risk of eye or face injury from
flying chips or lung damage from breath-
ing dust, always wear a faceshield, safety
glasses, and a respirator when operating
this machine.
Summary of Contents for T10814
Page 40: ...38 Model T10814 Mfd Since 5 15...
Page 44: ......
