5. PSJ-M2 installation
! PSJ-M2 gen.3 should be installed by specialists only !
Advanced knowledge of AEG replicas is crucial. Also basics in electronics and soldering skills are
needed. Never use soldering gun! Manufacturer takes no responsibility for damaged caused by
unprofessional installation!
5.1. Preparation
For PSJ-M2 installation, take gearbox out of your replica, open it and remove all of its content (pict.1).
Pict.1: Gearbox with all of its content removed
5.2. PSJ-M2 mounting
Insert your unit into gearbox, bottom side first (pict.2). If it does not fit properly, you need to adjust gearbox.
Prepare gearbox for smooth unit insertion. After your unit is placed, check for any conductive contacts with
gearbox. If there are any, you need to insulate them! You can sharpen your gearbox or you can use some
insulation material. Bottom side of unit is insulated by pre-installed insulation foil. Before final insertion, remove
protective foil from heat-conducting foil (pict.2). Now you can fix the unit with a screw and organise cables. Never
sharpen the unit.
Pict.2: Installed PSJ-M2 gen.2 with wires placed (wires to forearm)
Summary of Contents for PSJ-M2 gen3
Page 1: ......
