G1182 6" Heavy-Duty Jointer
-19-
3.
If there is a gap between the bevel’s blade
and the face of the fence, turn the stop bolt
until the gap is gone.
4.
Tighten jam nut. Move your fence forward,
then back against the stop. Re-check the
stop bolt.
Figure 21. Location of Stop Bolt and Stop Tab.
F. 45˚ FENCE STOPS
The fence can be tilted to 45˚ by loosening the
lock handle, lifting up the 90° positive stop tab,
and moving the fence in the desired direction. To
set the 45° tab stop:
1.
Loosen checknut and lower fence until it
rests on the stop bolt. See Figure 21.
2.
Using a bevel gauge set to 45°, place the
heel of the bevel on the outfeed table, and
the blade against the fence.
Figure 22. Jointer fence in 45° stop position.
Stop Bolt
Stop Tab
IX. ADJUSTMENTS (Continued)
Jointer knives are dangerously sharp. Use
extreme caution when handling knives or
working near them. Serious personal injury
may occur.
