-18-
G1182 6" Heavy-Duty Jointer
IX. ADJUSTMENTS (Continued)
E. 90˚ FENCE STOPS
To adjust the 90˚ fence stop:
1.
Place a square on the outfeed table fairly
close to the cutterhead. See Figure 19.
3.
Tighten the checknut on the stop bolt and tilt
the fence forward, then back against the
stop. Figure 20.
Figure 20. Location of the fence’s positive stop
bolt.
Figure 19. Use of machinist’s square to align
fence.
2.
Loosen the fence lock handle and the check-
nut on the positive stop bolt. Turn the bolt
against the tab until the fence contacts the
edge of the square evenly.
DO NOT attempt any adjustments while
your Model G1182 is running. Ensure that
the switch is off, power is disconnected and
moving parts have stopped before making
adjustments. Serious personal injury may
occur.
4.
Re-check with the square. Tightening the
checknut will move the stop bolt slightly, so
some trial-and-error may be necessary to
perfect your settings.
