Grizzly G1071, Owner'S Manual

Page: 18 / 40

-16-
Model G1071 (Mfd. Since 11/10)
12. Insert one 5 x 28 roll pin into the non-thread-
ed hole in each of the three table inserts, as
shown in
Figure 14. Make sure it does not
extend through the surface of the table insert.
Figure 14.
Inserting roll pins (bottom view).
Table Insert
Roll Pin
8. Move the square to various points around
the table to ensure the table and spindle are
square on all sides. Adjust the stop bolt as
necessary until the table rests on the stop
bolt and is square with the spindle (see
Figure 12).
Figure 12.
Table stop bolt (table tilted for clarity).
11. Re-tighten the jam nut to secure the table
stop bolt (see
Figure 12).
Figure 13.
Pointer adjustment.
Scale
Retainer Screw
Scale Pointer
9. Tighten both table lock handles when you are
satisfied with the position of the table.
10. Loosen the retainer screw (see Figure 13)
that secures the scale pointer and adjust
the scale pointer to read 0˚. Re-tighten the
retainer screw.
7. Using a machinist square, bring the table sur-
face square to the spindle surface as shown
in
Figure 11.
Note: It may be necessary to thread the table
stop bolt further into the base in order to
make the table square to the spindle.
Figure 11.
Checking table for square.
Table
Machinist's
Square
Spindle Surface