Grizzly G0945, Owner'S Manual

Page: 27 / 60

DO NOT exceed
1
⁄
8
" depth of cut per pass on
this machine or kickback and serious injury
may occur!
Figure 20. Location of depth-of-cut controls.
Straightedge
Outfeed Table
Infeed Table
Figure 21. Infeed table level with outfeed table.
Figure 22. Location of depth-of-cut components.
Model G0945/G0946/G0947 (Mfd. Since 06/21)
-25-
Setting Depth of Cut
The depth of cut on a jointer affects the amount of
material removed from the bottom of the workpiece
as it passes over the cutterhead.
Depth of cut is set by adjusting the height of the
infeed table relative to the outfeed table, and
cutterhead knives/inserts at top dead center (TDC).
Items Needed Qty
Straightedge 12" ................................................ 1
Hex Wrench 4mm .............................................. 1
Adjusting Infeed Table Height
To adjust infeed table height, loosen table height
lock knob, rotate infeed table adjustment knob
counterclockwise to raise table, or clockwise to
lower table, and then tighten table height lock knob
to secure setting (see
Figure 20).
Depth-of-Cut Scale
Depth of cut can be referenced directly from
the scale located on the front of the jointer (see
Figure 20).
Calibrating Depth-of-Cut Scale
The depth-of-cut scale on the infeed table can be
calibrated or "zeroed" if it is not correct.
1. Move cutterhead guard out of the way.
2. Place a straightedge across infeed and
outfeed tables.
3. Adjust infeed table until it is level with outfeed
table (see Figure 21).
4. Loosen button head cap screw on depth-
of-cut scale pointer (see
Figure 22), rotate
pointer until it is aligned with " 0" on scale, and
tighten screw.
Note: Hold pointer when tightening screw so
pointer does not accidentally rotate.
Depth-of-Cut
Scale
Table Height
Lock Knob
Infeed Table
Adjustment Knob
Depth-of-Cut
Scale Pointer
Button Head
Cap Screw