Grizzly G0869, Owner'S Manual, Page: 20 / 72

-18-
Model G0869/G0870 (Mfd. Since 01/19)
Figure 6. Table saw box inventory 1.
B
C
D
E
F
H
Figure 7. Table saw box inventory 2.
I
J
K
L M
N
Figure 8. Table saw box inventory 3.
O
G
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Table Saw Box (Figures 6–8) Qty
A. Table Saw Unit (Not Shown) ...................... 1
B. Blade Guard ............................................... 1
C. Spreader ..................................................... 1
D. Pawl Assembly ........................................... 1
E. Push Stick .................................................. 1
F. Arbor Wrench ............................................. 1
G. Miter Gauge ................................................ 1
H. Riving Knife ................................................ 1
I. Table Extension Rest ................................. 1
J. Flat Washers 6mm ..................................... 2
K. Cotter Pins .................................................. 2
L. Phillips Head Screws M6-1 x 10 ................. 2
M. Table Extension Lock Knobs ...................... 2
N. Table Extension Shafts .............................. 2
O. Fence.......................................................... 1
Roller Stand Box for G0870 (Figure 9) Qty
P. Roller Stand (Not Shown) ........................... 1
Q. Left & Right Handles (Not Shown) .......1 Ea.
R. Carriage Bolts M8-1.25 x 40 ....................... 4
S. Button Head Cap Screws M8-1.25 x 16 ..... 2
T. Hex Wrench 5mm ....................................... 1
U. Flat Wrench 10mm/13mm .......................... 1
V. Wheels ....................................................... 2
W. Lock Nuts M8-1.25 ................................... 10
X. Button Head Cap Screws M8-1.25 x 40 ..... 4
Y. Flat Washers 8mm ..................................... 6
Figure 9. Roller stand box inventory.
R
X Y
W
S
V
U
T