-36-
Model G0852 (Mfd. Since 12/18)
The Model G0852 dust collector uses a crank
handle and internal brushes to remove excess
dust and debris from the filter pleats. Before each
use, rotate the handle to knock dust into the filter
bag. Dispose of bag when it becomes
1
⁄
2
full of
dust.
After extended use, the filter should be replaced,
or thoroughly washed by hand.
To wash filter by hand:
1. DISCONNECT MACHINE FROM POWER!
2. Remove plastic filter bag, firmly tie it closed,
then dispose of bag.
3. Remove canister filter (see Page 39).
4. Rinse filter with water in an appropriate out-
door location.
IMPORTANT: DO NOT use a pressure wash-
er to clean the filter, as this can damage filter
fibers. DO NOT use compressed air to clean
or dry filter, as this can spread fine dust into
air and damage filter fibers.
5. Allow filter to air dry only. DO NOT use heat.
Washing Canister
Filter
Emptying/Replacing
Collection Bag
Dispose of the collection bag when dust fills it
about
3
⁄
4
full. Immediately replace the bag if it
develops a leak or becomes damaged.
If the bag gets overfilled, the dust will be sucked
into the intake barrel and passed through to the
canister filter and filter bag. Avoid allowing this to
happen, as it may reduce filter life.
Items Needed Qty
Collection Bag T30328 ...................................... 1
To remove and replace collection bag:
1. DISCONNECT MACHINE FROM POWER!
2. Release bag clamp on collection lid (see
Figure 62).
3. Remove bag from lid and dispose of contents.
4. Place new dust bag on collection lid.
5. Re-install bag clamp to secure.
Figure 62. Collection bag components.
Collection
Lid
Bag
Clamp
Collection
Bag
Summary of Contents for G0852
Page 52: ......