Model G0846 (Mfd. Since 02/18)
-29-
Table Elevation Ways
Lubrication Frequency ........... 8 hrs. of Operation
Oil .............. Grizzly T27914 or ISO 68 Equivalent
To lubricate table elevation ways, fully lower the
table with the elevation handwheel (see
Figure
32). Clean each way with mineral spirits, let dry,
then apply a light coat of oil. Raise and lower the
table to evenly distribute the oil.
Figure 32. Table elevation ways lubrication
points.
Elevation
Handwheel
Table
Elevation
Way
(1 of 2)
Lubrication Frequency ......... 90 hrs. of Operation
Grease ...... Grizzly T26419 or NLGI#2 Equivalent
To lubricate table elevation leadscrew:
1. Fully lower table (see Figure 33).
Table Elevation Leadscrew
Lubrication Frequency ... 8 hrs. Or As Necessary
Grease ...... Grizzly T26419 or NLGI#2 Equivalent
Remove accumulated sludge caused by sawdust
and debris from the table roller bearing V-ways
and wheels as often as necessary to maintain
smooth table movement.
To lubricate table roller bearing V-ways:
1. Use mineral spirits, stiff brush, and shop rags
to clean table roller bearing V-ways and roller
bearing wheels where shown in
Figure 34.
Table Roller Bearing V-Ways
Figure 33. Leadscrew lubrication point.
Elevation
Handwheel
Table
Elevation
Leadscrew
Figure 34. Cleaning and lubrication points for
table roller bearing V-ways and wheels (left side
shown).
Roller Bearing Wheels
Roller Bearing
V-Ways (3 of 4)
3. Apply thin coat of NLGI#2 grease to threads.
4. Raise and lower table to evenly distribute
grease.
2. Clean threads with mineral spirits and allow
to dry.
2. Allow to dry.
3. Apply thin coat of grease to V-ways.
4. Move table back and forth and side to side to
evenly distribute grease.
Note: If after lubrication you notice that the
table has excessive free play, two eccentric
rods under the right side of the work table can
be adjusted. Refer to
Adjusting Table Roller
Bearings on Page 33.
Summary of Contents for G0846
Page 52: ......